| |
|
Product Information |
Price |
| |
 |
Model #: MO349
* Free shipping on your entire order when you purchase this product!
This is a factory vacuum motor for the Power Star Utopia central vacuum, 240 volt. systems.
This is the primary vacuum motor (inside center motor).
If you need the secondary motor for the PowerStar Utopia central vacuum system see our part #MO350.
It is suggested you replace the motor gasket part #MO400.
Protect your motors from dust and dirt by using a motor filter. This prolongs the life of your motor and is a must for all motors. See our part #MO553. |
|
|
| |
 |
Model #: MO512
Fits 4.3, 4.8, 5.1 and 5.7 inch diameter motors.
This flat motor gasket is of the highest quality neoprene and designed to last for years. It is crafted to be heat resistant and does not dry and crack like cheap motor gaskets do. The cheap motor gasket will break down over time due to heat and allow leakage resulting in loss of power.
Always replace the motor gasket when you replace your vacuum motor! This provides a tight seal for the motor which eliminates air leaks as well as absorption of motor vibration allowing the motor to perform smoothly and safely. |
|
|
| |
 |
Model #: MO511
Fits 7.2, 7.5 and 8.4 inch diamter motors.
This flat motor gasket is of the highest quality neoprene and designed to last for years. It is crafted to be heat resistant and does not dry and crack like cheap motor gaskets do. The cheap motor gasket will break down over time due to heat and allow leakage.
Always replace the motor gasket when you replace your vacuum motor! This provides a tight seal for the motor which eliminates air leaks as well as absorption of motor vibration allowing the motor to perform smoothly and safely. |
|
|
| |
 |
Model #: MO513
This factory fan guard cover replacement fits most Lamb Ametek motors. Compare this to the fan guard you are trying to replace.
Measures 3 3/8 inches at the base and 3 inches from the top where the fan guard is. |
|
|
| |
 |
Model #: MO553
Only to be used on 5.7 inch motors! Will not fit 4.8 or 7.2 inch motors.
Motors need to be protected from dust and dirt entering them. It is crucial that only clean air is taken into the motors. This protects any buildup of dust and dirt on the fan blades increasing the life of the motor. This buildup blocks the fans from flowing air properly and greatly dimenishes performance of your vacuum system, not to mention leading to motor failure.
Ametek Lamb specifically states in their warranty information that "typical signs of abuse inludes dirty motors, failure of which was (or is) caused by inadequate filtration will NOT be considered in-warranty failures". In other words, it is required to adequately protect the fan blades of the motor from dirt and debris or risk being out of warranty.
Just place the motor filter on the bottom (the fan side which is the widest part) of the motor with the black filter side facing down. Then place your motor and the filter on to your motor gasket. Secure the motor as required.
Protect your motor so it provides you with many years of trouble free service! |
|
|
| |
 |
Model #: EP707
* Free shipping on your entire order when you purchase this product!
This is a factory control module for the Power Star Optima Plus model #99193.
This will ONLY fit the Power Star Optima Plus central vacuum. |
|
|
| |
 |
Model #: EP706
The complete relay and PC board fit all Power Star II and Power Star III vacuum systems, 120 volt. |
|
|
| |
 |
Model #: EP708
This is the factory Control Module/PC Board for ALL versions of the Eureka CV1801 Central Vacuum.
Eureka part #102001. |
|
|
| |
 |
Model #: EP710
* Free shipping on your entire order when you purchase this product!
This is a factory control module for the Power Star Utopia model #99194 240 volt central vacuum.
This will ONLY fit the Power Star Utopia central vacuum.
This is the MASTER PC board not the slave PC board. |
|
|
| |
 |
Model #: EP709
This is a factory replacement PC Board for all Titan Central Vacuums.
It will fit models TCS-5525 and TCS-8575. |
|
|
| |
 |
Model #: MO551
Factory replacement relay for the Nutone CV-350, CV-350C, CV-353, CV-353C, CV-400, and CV-400C central vacuum systems.
Includes complete wiring diagram and instructions.
This Relay will only fit Nutone metal Nutone Vacuum Units not the VX Series vacuums.
|
|
|
| |
 |
Model #: MO552
* Free shipping on your entire order when you purchase this product!
This is a factory Hayden Control Module for the Hayden 3600, 6000, and 9000 Premier central vacuum systems.
This fits ONLY the Hayden Models 3600, 6000, 9000 Premier vacuum systems only! |
|
|
| |
 |
Model #: MO557
Factory Control Module for Hayden 2400 central vacuum system, 120 volt.
This fits ONLY the Hayden Model 2400 central vacuum. |
|
|
| |
 |
Model #: MO554
This is a rotating fan blade for Ametek motors 115330, 115334, 115478, 115637 motors. |
|
|
| |
 |
Model #: MO558
Fan blades for an Ametek 114787 motor. |
|
|
